DHC repairs #12: Start of the body repairs

Last weekend I visited the workshop where the DHC’s body is undergoing some much needed repairs. First job was inspecting the pile of body parts left over from the donor body shell. The result of drilling and grinding every evening for two weeks. A small selection of the most important parts for the body’s repairs;

The left hand rear wing.

The panel covering the front of the right hand rear chassis leg.

The strengthening on the inside of the right hand B-post

The inside of the left hand outer sill and the B-post panel.

Strengthening panel inside the front of the right hand rear chassis leg

The rear chassis legs.

And with the various parts inspected it was time to put the angle grinder into the body. But not before a simple brace was fitted to prevent distortion of the body. To check this, the doors were also fitted to the body. And some control measurements were taken.

After which it was time to put the angle grinder to the right hand sill. As you can see there is a fair amount of tin worm in that sill;

The old sill and its second hand replacement.