A suspension check

After the recent edition of our Nachtrit I decided it might be a good idea to give all suspension pick up points from ‘t Kreng a thorough check. This was prompted by some knocking from various parts of the suspension, mainly from the back of the car and at low speeds.

And to carry out this check properly I (again I should say) used a friend’s work shop, and one of his 4-post lifts. Makes life so much easier, as it gives much better access to all mounting points.

I started with the back axle, unscrewing all eight mounting bolts. A few turned out to be slightly loose, but nothing worrying. More importantly, none of the bolts had seized inside the (poly) bushes’ stainless inserts. The insulation paste I added well over 10 years ago had clearly payed off! And after moving the bolts around a bit they could be torqued down again. The back axle’s wheel bearings also turned out to be fine with no play in axial and radial direction.

It also gave me a good view of the bottom of the car. And yes, it won’t win any prizes at a car show. That was never the intention. But glad that everything is still in pretty good condition and solid. Also no visible cracks around the mounting points, nor any visible deterioration or damage on the various poly bushes. And that despite nearly 25 years of (sometimes pretty hard) use!

Next in line was the front suspension. As with the back axle, the wheel bearings turned out to be fine. And there were no problems with the various mounting bolts either. Though the lower sub frame bushes (Triumph Tune 70 shore rubber items) clearly are showing signs of wear and old age. So these will have to be replaced over the winter. As can be seen in the pictures below the rubber bushes between sub frame and the chassis leg have already been replaced with solid alloy ones, and the TCA bushes have been deleted many years ago for spherical joints. And this of course results in all kind of irrelevant noises being directly transmitted to the cars interior!

Final check were the suspension’s coil-over top mounts. No further action needed! Forgot the pictures though, so I’ll bore you with a recent picture 😜