FHC resto nr. 167; Steering column

Finished another small job today, the steering column to be precise. Actually this job started in the summer of 2017 when the parts from the column (together with lots of others) were sent of for coating. In this case e-coating for the two parts of the column itself and zinc plating and (black) passivating for the other parts of the column.

Time to search together all the necessary (coated) parts and assemble the column. Here the biggest problem was remembering where I had stored them. But in the end all were found in various locations. A few hours wasted there again I dare say!

And with the handful of parts back home in the garage the assembly of the column was pretty straight forward. Though putting the two pieces of the column together did need some persuasion with a light copper hammer. After which fitting the two clamps was easy. I even remembered to use the correct torque figures for the allen head clamp screw (20 Nm) and the lock nut (50 Nm).

And maybe you are wondering why the teaser picture at the top of this post? Well that picture is hiding something that is about to happen in the next few weeks if all goes well!

FHC resto nr. 166; Interior light

Or small steps at a time, to get the ’76 car finished! Several years ago I spent some time cleaning this early roof mounted interior light, which I found among my spare parts. This was removed from a parts car a friend broke in 2016. The light corrosion on the metal parts is clearly visible in the pictures below

Fast forward to September 2020 and I found some time to clean the light properly. For this I used the same method as for cleaning the connectors of the various wiring harnesses. Which meant immersing the armature in a solution of rock salt, dissolved in hot water and cleaning vinegar. After leaving it in this solution for 15 minutes it was rinsed of with clean water and dried. Final job was getting rid of any remaining oxidation with an assortment of small wire brushes.

The cover was cleaned using hot water and liquid dish soap. With a final polish with tooth paste and an old electric tooth brush. And as a finishing touch I painted the outside silver, using a Tamiya paint marker.

And while I was in the shed today, to check a few things for the repairs of the DHC, I thought it a good idea to fit the interior light to the inside of the roof. Mainly because I had it in my hands for the umpteenth time! A rather straightforward job. Although I took a little extra time to make sure I had the correct location, before cutting a hole in the custom made head lining!